Hello bmeup.
I would be very pleased to send you a photo -- if ony I knew how to do it!
I have now looked on FAQ and found the answer to posting photos - so I have put one on 'my profile'.
Don't be put of by the 'heath-Robinson' look of the gadget as all my gadgets are prototypes made up of anything that may be handy in my shed!
You can just see two holes on the baseplate either side of the spout. this was where the other two 'eyes' were for the second string-tie. However, this didn't work very well as the strings go on the outside of the irrigation sleeve and the bottom line would have either blocked the outlet or have to be pierced through the sleeve which would leave it liable to leakage. Hence the bit of black plastic stuck on the outside of the spout which allows a belt to be tightened round the whole gadget without interfering with the spout outlet. It works perfectly well with just the belt but I always put the top string on as well for 'safety' reasons. I didn't like the idea of having to fish about down the loo for it if it ever came off !!
It should perhaps be said that I only use this gadget if and when I can see there is a problem with the adhesive on the irrigation sleeve -- this happens in approximately 2% of the sleeves I use, so it's not very often, but it's useful to have an immediate solution close at hand when it does happen.
Best wishes
Bill