The topic is about finding alternatives or solutions for the Braun Irypump, a device that has been discontinued. The original poster's wife has been using this pump for over six years, and now they are looking for replacement options or ways to fix the existing pump.

Here are some suggestions and insights:

1. There is no direct replacement for the Braun Irypump. Many users have switched to using a gravity water bag, although some find it less effective.

2. If the pump's only issue is a dead battery or charger, you can try a DIY conversion to a 12-volt mains power supply. Here’s a brief guide:
- You will need a few parts, which can be found on Amazon UK:
- A DC 12 V PWM motor speed controller
- A 12 V 6 A Power-Supply Transformer Adapter (or any 12 V 5–6 A adapter)
- Waterproof 2-pin automotive plug connectors
- A 6 A in-line cord switch
- A cable clip from an old 3-pin plug and a small pad of Blu-tack
- The basic steps include drilling a small hole in the pump casing, removing the base, cutting the two red/black motor wires from the circuit board, routing them through the hole, and attaching them to the PWM controller. Connect the power-supply leads, add the in-line switch, secure everything with Blu-tack and a cable clip, and test the pump with water at a low speed. This setup allows the pump to run from a 240 V mains supply, converted to 12 V DC, bypassing the failed battery.

3. For professional repair options in the UK:
- There is an eBay service offering Irypump repairs for around £49.
- ELECFIX in Cornwall, UK, is another option. You can contact Mark at 07779 654 251. This service is often praised for its quick turnaround and also buys old pumps for parts.